Thank You Ferns Card
By Ann Barba
Designer Tip: Use embossing powders on your Double-Stick Dazzles™ for a unique look—no heat gun needed!
- Place your card with the fold on the top. Cover the card front with brown vertical stripe paper. Glue 6 1/2" x 2" of blue/ivory herringbone along the card 1 1/4" from the top. Glue 6 1/2" x 1 1/4" of brown/ivory lace border along the card 1 3/8" from the top. Use Design Tool Kit #2 to cut out a Fancy Label from ivory pattern paper. Place "Thank You" in the center. From the Teal Encrusted Jewels set, open up the "Detail Capri Embossing Powder" and sprinkle onto the greeting. Rub in with your fingertip and tap off excess. Mat the label onto green paper, leaving a 1/16" border. Foam tape to card going off the left edge slightly, 1/2" from the top. Trim the excess. Fold a short piece of dark brown ribbon in half and cut a V in each of the ends. Tuck behind the right side of the label, using Zots to adhere.
- Place two swirls on either side of "you" and a small flower above "Thank". Place the three ferns on the card as shown, trimming the edges that hang off the sides. To create the middle bottom leaf arrangement, use 6 separate leaves in an alternating pattern as shown. Place a scattering of double stick circles around the ferns as shown. Open the jar of "Sky Blue Embossing Powder" from the Teal Encrusted Jewels set. Sprinkle onto all the sticky Dazzles, rubbing in with your finger. Tap off excess (do not heat set).