| Snowflake Card By LeNae Gerig |
|
Designer Tip: Place the card fold on the side and cover the front with Gingerbread Foil Artful Card Kit red dot paper. Cover the inside front with chevron stripe and the back with 3½” wide blue snowflake paper. Open the card and align the alignment nibs on the pop-up die over the center fold of the card with the cutting blades against the card, so the opening is centered between the card top and bottom. Tape the stencil to the card using stencil tape and die cut. Trim 7/8” from the left side of the card front only and fold the card front back. Foam tape the die-cut label and large silver foil snowflake to the front window. Use a length of 3/8 wide red Gingerbread Satin Ribbon to make a bow and Zot™ to the card front as shown. Glue a silver tag die-cut to the inside of the card as shown and foam tape a greeting cut-out to the tag. Zot™ a knotted length of ribbon to the top. Glue die-cut border to the right of the fold and silver swirls and peppermints to the right as shown. Die cut a blue snowflake die-cut pop up tab and fold the tabs inward and place glue on each end. Glue one end on each side of the card fold and glue a snowflake die-cut to the tab as shown. Supplies:
|
|
|
|
